Route Sentry

• Route sentry allows you to use two ADSL accounts on the same PC at the same time.
• One account is used to connect to international sites using international bandwidth.
• The other account does the same on a local platform using local bandwidth.
• Route sentry will direct local traffic through the local account and international traffic through the international account.
• Route sentry will automatically reconnect once your router drops a connection whether your IP changes or not.






Setting up your ADSL connections

NOTE:
• You will need to set your router to bridge mode before using this program.
• You will then need a dial up connection instead of the routed connection.
• "Automatic reconnect" needs to be disabled as this may prevent the program from working.


Configuring Route Sentry

1. Route Sentry Enabled
• You can deselect this to disable Route Sentry.

2. Local Connection
• Refers to the connection used for local access.

3. Automatically Reconnect Local Connection
• If selected Route Sentry will automatically attempt to reconnect if your connection has dropped.
• It will also cause the connection to automatically connect when Route Sentry attempts to start up, if the connection is not already connected.

4. Disconnect Local or Connect Local
• This allows you to connect or disconnect the local connection.

5. International Connection to use
• The connection will be using international bandwidth.

6. Automatically Reconnect International Connection when Disconnected
• Route Sentry will automatically attempt to reconnect if the connection is dropped.
• It will also cause the connection to automatically connect when Route Sentry attempts to start up, if the connection is not already connected.

7. Disconnect International or Connect International
• This allows you to either connect or disconnect the international connection.

8. Automatically Set up Routes when both Connections are Connected
• When setup, it set"s up an IP routing table to route traffic through the appropriate connection when both connections are connected.

9. Set up Routes Now
• When setup, Routing table to be updated immediately.
• Both connections must be active for this to work.